Replacing floors comes under the coverage of remodeling and may be regulated by local building codes. A permit may be necessary. Many areas require a permit if more than $100 of work will be done. Always check your local building code before beginning work.
Design
Often you will be replacing a floor because it is damaged or worn you will not be completely redecorating a room at the same time. In this situation the decor aspects which you are retaining will give you clues as to which way to go with color and pattern for your floor.
The color you choose will be determined by the predominant color of the room. Neutral tones and single color dominant rooms will make your decision easy. For an obviously multicolored space you will need to determine which color you prefer to emphasize.
For pattern selection, keep in mind that patterns can be combined but are most effectively done by using one large pattern, one medium pattern and one small pattern distributed among walls, fabrics and flooring. These of course should be color-coordinated. If your floor offers a wide expanse of uninterrupted space, a larger pattern may be used. If, however, it is broken up spacially, has alcoves or is interrupted by counters or appliances, a more pleasing effect will be accomplished with a smaller pattern.
You can utilize the pattern to create a visual span from one space to another by repeating like shapes in three by three sections both vertically and horizontally.
What you will Need
Time. Most vinyl floor installations can be completed in one or two days by a single worker. If restructuring is needed, extra time will be necessary. For a 9 x 12 room, full-spread adhesives will require 9 – 11 work hours.
Tools. Vinyl floor installations require very few tools that are not in every home- owner’s toolbox and good ventillation.
Pry bar
Utility knife
Handsaw
Hammer
Scissors
Pencil or ball point pen
1” wide ruler
Notched blade or utility knife
Notched trowel
Rolling pin or seam roller
Staple gun
Chalk line
Carpenter’s square
A hair blow dryer might come in handy, to heat up tiles for making complicated cuts.
Materials
Craft or butcher paper
Do-it-yourself installation kit
Masking tape
Sheet vinyl or tiles
Adhesive
Seam sealer kit
Staples Vinyl
wall base
If it is necessary to restructure your sub floor before laying the vinyl, you may also need:
Leveling compound
3/4” T & G plywood
1/4” plywood
6 penny ring shank nails
Common Mistakes
The single most common mistake in any vinyl flooring project is applying the flooring over an improperly cleaned or prepared floor such as a basement floor that has a moisture problem. The other frequently made mistakes are listed before each step.[/vc_column_text][/vc_column][/vc_row]